1
2
3
4
5
6
7
8
9
10
11
12
13
14
Use some heat-tolerant double-stick tape to mount a strip to the center of each aluminum segment.
Don't put tape too close to the ends! It'll burn when we solder the strips!
The tape may not be necessary if your strips are particularly wide. If the channel in the extrusion holds the strip securely on its own, no tape is needed.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help