Before continuing, make absolutely sure that the strips and hubs are correctly oriented.
Double-check that the Top piece keyholes have the narrow bit facing up, and the circular bit facing down.
Seriously, be careful. This glue is permanent.
Mixing small batches at a time, epoxy the segments into the hubs. They should bottom out into their slots.
Ventilate the room with fresh air, and allow the epoxy to fully cure before continuing.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.