1
2
3
4
5
6
7
8
9
10
11
12
13
14
Cut a segment of stripboard 21x30 holes wide.
Using a sharp knife or Veroboard tool, split the stripboard’s copper conductors where indicated by green lines.
Solder in two wire jumpers, a 2.1mm jack, two female 19-position headers, a 5mm 2-position terminal, and a 2.54mm 8-position terminal as shown.
Solder headers to the Node32S module and mount it.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help